2020MexicoDetergents and hygieneIndustrial wastewater
A Mexican manufacturer of detergents, hygiene and health products was exceeding the local discharge limits. It also wanted to recover part of the treated water.
235 m³/day
treatment plant capacity
01
The wastewater had high BOD₅ and COD, ammonium nitrogen, surfactants, oils and fats. The pH swung between 0 and 11 because acidic and alkaline discharges alternated.
pH 0–11
range at the inlet
235 m³/day
design flow rate
8 m³/h
average load
02
First the pH is stabilized, then comes the membrane bioreactor and finally a polishing stage so the water can be reused.
STEP 1
Chemical and physical equalization of the acidic and alkaline effluents stabilizes the pH.
STEP 2
Aerobic biological treatment with submerged ultrafiltration membranes, nitrification and denitrification.
STEP 3
Filtration through activated carbon and a flint bed improves the quality and odor of the water.
STEP 4
Lime dosing, thickening and dewatering in a low-pressure filter press.
STEP 5
The treated water can be reused.
03
The main pollutants dropped enough for the discharge to meet the Mexican standards with a margin. BOD, COD, suspended solids and surfactants stay low, the pH is stable and there is hardly any odor, so the water can be reused. The plant is ready to be expanded.
Stable pH
after equalization
Water recovery
for reuse
Expansion
plant ready for a higher flow rate
01
2021 · Portugal · PPE manufacturing
DAF · MBR · ultrafiltration
> 30 000
mg/l of COD at the inlet
20 m³
per day
Discharge limits met, water suitable for irrigation.
Read the case study →
03
2009 · Valencia, Spain · Food industry
Vacuum evaporator · spray drying
TDS < 100
ppm in the distillate
55,000 l
per day
Evaporator heated with waste heat from cogeneration.
Read the case study →
04
2008 · Murcia, Spain · Chemicals and cosmetics
MVR evaporator · crystallizer
7 000 → 50
µS/cm conductivity
3 000 → 5
mg/l of chlorides
Zero liquid discharge. An award-winning project for its environmental benefit.
Read the case study →
Wastewater with variable pH and surfactants?
We look at the composition of your wastewater and tell you whether an MBR with polishing would let you recover part of the water.
OFFICE
Avda. Cabrera, 36
08302 Mataró (Barcelona), Spain
info@wizzum.com
© 2026 Wizzum. All rights reserved.
