Home / Blog / Air and VOCs

AIR AND VOCs

When not to replace your thermal oxidizer: the limits of "green" solutions

Biofilters and catalytic systems have real environmental advantages, but they are not always the best technical choice. In several situations, the thermal oxidizer is still the most effective, the safest and the cheapest over its whole service life.

W
WIZZUM engineering teamPublished on 06/06/2023 · Updated on 16/11/2026 · 5 min read

CONTENTS

IN SHORT

  • With toxic or non-biodegradable compounds, silicones and abrasive dust, a thermal oxidizer holds up better than a biofilter or a catalyst.
  • The RTO copes well with variable flow rates and irregular VOC concentrations thanks to its thermal inertia.
  • When a low emission limit combined with a high inlet VOC concentration in practice requires a destruction efficiency of 98% or more, thermal oxidation is the benchmark.

“Green” technologies, such as biofilters and catalytic systems, bring real environmental benefits. That does not mean they are always the best technical and operational solution. These are the situations in which the thermal oxidizer still wins.

Thermal oxidizer: when not to replace it with a biofilter or a catalystWhen to keep the thermal oxidizerFour situations in which thermal oxidation winsToxic compoundsor non-biodegradable onesChlorinated hydrocarbons, phenols,halogenated solventsSiliconesor abrasive dustThey poison the catalyst; the oxidizeralso needs good prefiltrationVariable flow rateand VOC concentrationsThe RTO has thermal inertiain its ceramic bedsVery high efficiencyis requiredE.g. destroying more than 98% of VOCs:oxidation as the benchmarkAt least one “yes”A thermal oxidizer (RTO) is usuallythe safest option.All “no”Consider a biofilter or RCO,but after a feasibility study.Source: WIZZUM article. Decision based on a technical assessment, not on image pressure.wizzum.com
Diagram: four situations in which it makes sense to keep the thermal oxidizer.

1. Toxic or non-biodegradable compounds

Biofilters and bioscrubbers rely on microorganisms that break down VOCs. That is why they struggle with compounds that resist biodegradation or are toxic to the microorganisms: chlorinated hydrocarbons, phenols, halogenated solvents and volatile metals. Even traces can cause partial failure, odor problems and non-compliance.

Thermal oxidation, at temperatures of up to 1000 °C, destroys these compounds by combustion and does not depend on the state of the biology. That is why it works well in aerospace, electronics and specialty chemicals.

2. Abrasive dust or silicones in the gases

Silicones can poison a catalyst within a few weeks, and abrasive dust, such as metal dust or ash, destroys filter beds and catalytic coatings. Under these conditions, thermal oxidizers with a robust combustion chamber and good prefiltration last longer.

Without that protection, the catalyst or filter bed has to be replaced much more often, which makes operation more expensive.

3. Variable flow rate and irregular VOC concentrations

Catalytic and biological systems work best with a stable flow rate and load. Frequent start-ups and shutdowns or pulsed emissions reduce their efficiency. Regenerative thermal oxidizers (RTO) have thermal inertia and operate stably even with fluctuations.

The RTO’s ceramic beds store heat, so short-term changes in VOC concentration do not upset the installation.

4. Demanding legal requirements and audits

BAT conclusions and integrated environmental permits usually express VOC limits as a concentration in the exhaust gases (mg/Nm³), not as a percentage reduction. But with a high inlet concentration, meeting a low outlet limit in practice requires a destruction efficiency of 98–99% or more. Thermal oxidation is then the benchmark solution, especially when the result has to be confirmed by emission measurements, in an audit or in an ESG review.

5. An unbiased view

We warn against the “green rush”, that is, installing systems without a full technical feasibility study. It ends in lower efficiency, faster wear of the installation or unplanned maintenance. When biodegradability, flow variability or chemical load cannot be safely controlled by another method, thermal oxidation is often the most environmentally responsible option. The full comparison of technologies is in the article “RTO, RCO or biofilters”.

Conclusion

The technology has to be chosen on the basis of a technical assessment, not image pressure. At WIZZUM we assess each case objectively and design an emission reduction strategy tailored to the emission profile, the operating constraints and the legal requirements.

Frequently asked questions

Is replacing a thermal oxidizer always greener?+

Not necessarily. A "green" system that cannot handle a particular pollutant profile can mean low efficiency, regulatory problems or greater risk to the environment.

What maintenance does a thermal oxidizer need?+

Routine maintenance: scheduled inspections, burner calibration and heat exchanger cleaning. It is less sensitive to variable load and pollutant composition than biological or catalytic systems.

Does a thermal oxidizer work with low VOC concentrations?+

Yes. Thanks to heat recovery, the RTO achieves high destruction efficiency even at low concentrations.

Are "green" systems cheaper?+

They may need less investment, but the whole life-cycle cost has to include maintenance, durability, the risk of shutdowns and regulatory compliance. With large loads and gases of complex composition, thermal oxidizers are usually more reliable and more cost-effective.

W

AUTHOR

WIZZUM engineering team

We design and commission wastewater and gas treatment installations for industry, from benchmarking and FEED engineering to start-up.

NEED HELP?

Are you thinking about replacing your thermal oxidizer?

  • Comparative technical analyses
  • Design and delivery of turnkey installations
  • Environmental benchmarking and BAT analysis

Environmental engineering for industry.
Industrial wastewater, emissions and odors.

OFFICE

Avda. Cabrera, 36
08302 Mataró (Barcelona), Spain
info@wizzum.com

© 2026 Wizzum. All rights reserved.